Universal Remote MRF-350 Manuale di Installazione Scaricare il pdf (Pagina 7)

MRF-350 BASE STATION

Page 4

5. Observe the RF LED of the RFX-250. Cup your hand over the RFX-250’s

RF LED. If it is glowing or flickering you must relocate the RFX-250 to a

location where the LED doesn’t flicker.

6. Observe the STATUS LED of the MRF-350. It is a little more sensitive

than the RFX-250. If you see any flickering of this LED, move the RFX-

250 to a new location.

If your installation location simply doesn’t offer you any choice and

you are detecting interference everywhere you place the RFX-250 you

have three last resort options:

a. Remove the RFX-250’s antenna. This will reduce the range

enormously, but may still be enough for this client.

b. Extend a wire to another room. Try this over the floor first,

before attempting to conceal the wire.

c. Admit defeat and install a “pointing again” IR repeater system.

If no buttons are pressed on any

remote control, no valid RF transmis-

sions are being received. The flickering

or glowing RF LED warns you that the

RFX-250 is detecting RF interference

generated or reflected near this

location. MOVE the RFX-250 to a new

location.

The flickering or glowing STATUS LED warns you that the RFX-250 is detecting RF

interference generated or reflected near this location. MOVE the RFX-250 to a new

location.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Nessun commento

Universal Remote MRF-350 Manuale di Installazione Pagina 7